Page 1 of 1
Door Panels
Posted:
Wed Nov 30, 2016 10:01 pm
by Dayton Parkville
This weekend I am entering the Corvair in a local car show called The East Coast Nationals. It won't win anything but it will be fun to show off all the hard work.........anyway...........A friend of mine does some pretty outrageous bead rolling and offered to do some " performance " looking door panels and quarter panels for the car. The interior was pretty nice but was all wrong for the V8 version of the car. I went to my friends house tonight and picked up my new panels. I can hardly wait to put them in tomorrow but had to show them off.
The new driver's door panel
in this last shot you can see the console cover sitting above the quarter panel
Re: Door Panels
Posted:
Thu Dec 01, 2016 12:16 pm
by Richard Miller
Your friend is an artist with the bead roller. I have never seen bead rolled aluminum made to look like upholstery - especially the "stitching ". Truly a unique and new piece of work.
Re: Door Panels
Posted:
Tue Feb 28, 2017 1:19 pm
by Rick Andersen
Those panels are incredible!
Re: Door Panels
Posted:
Thu Jun 14, 2018 3:20 pm
by Dayton Parkville
It took me a while to finally get around to doing the interior panels. Today, I added the driver side panels...………….They were close but I needed to make some changes...….only screwed up one...………………………...so this is how they look
Re: Door Panels
Posted:
Fri Jun 15, 2018 12:33 am
by Rick Andersen
They look tremendous! You should see if he would want to make a run of 5 or so sets just to see how much interest there might be for selling them.
Re: Door Panels
Posted:
Fri Jun 15, 2018 7:32 am
by Richard Miller
I am with Rick ,, those do look GREAT ! I have seen many "Tin Interiors " before but never one like that ,, it is sure to get a lot of attention at your next show . Also nice looking center stack on your dashboard ,, switchpanel
Re: Door Panels
Posted:
Fri Jun 15, 2018 7:44 pm
by Goodman Alabama
Gotta love those door panels! I like the tilt column, what is that out of and what was involved in the install?
Re: Door Panels
Posted:
Mon Jun 25, 2018 6:32 pm
by Dayton Parkville
See if I can answer some questions
1. The column is an Ididit 31 inch unit with turn signals and emergency flasher.
2. Switch panel...very old mod........I just changed over to roll up windows so middle 4 are no longer valid.........the end switches are the door popper switches
My buddy who did the panels just got married a couple of months ago..........he probably has more to do than make door panels.............but I could be wrong
The column was a snap to install. I need another steering wheel
Re: Door Panels
Posted:
Fri Aug 03, 2018 7:05 pm
by Dayton Parkville
I took the number 10 screws out of the door and went with some black and chrome #12 hardware.....kind of industrial...…….I like it
corvair door.jpg