by Richard Miller » Tue Aug 14, 2018 11:09 am
kit was an easy install ,, I put the sender into the plug at bottom center of block , down near the oil pan rail .. reused stock corvair wire running to rear for warning light ,, ignition switch on light comes on and stays on until engine warms and build a little pressure in cooling system ,, it will flicker on and off until then with changes in rpm as water pump builds some pressure ,, this might not happen with electric pump ,, switch operates at 3 psi , I tested it before install ,,
Richard Miller
West Covina, Ca
'65 V8 Vair