Clarks Pinion shaft
Posted: Thu Jun 11, 2015 7:49 amhas anyone used the Clarks pinion shaft in the Crown Conversion? it is supposed to be stronger but it measures thinner
V8RegistryForum.com
Dedicated to those with Chevrolet Corvair Drivetrain Conversions
https://v8registryforum.com/
Clarks Pinion shaft
Page 1 of 1
Posted: Thu Jun 11, 2015 7:49 amRe: Clarks Pinion shaft
Posted: Tue Jun 16, 2015 8:50 amI don't know right off myself how well the HD pinion shaft holds up to to a v8. I will buying one of them or a good stocker next week.
Re: Clarks Pinion shaft
Posted: Tue Jun 16, 2015 9:06 amRick Norris had an HD pinion shaft in the white Crown v8 car when it was being built. The new owner of that car can tell you how it'sholding up.
Re: Clarks Pinion shaft
Posted: Tue Jun 16, 2015 1:45 pmI am the current owner of Rick Norris's white Crown car. To the best of my knowledge it has the same pinion gear that Rick installed back in 2000 and it seems to be holding up just fine. https://www.corvaircorsa.com/norris09.html#1
Re: Clarks Pinion shaft
Posted: Thu Jun 18, 2015 3:36 pmIm pretty sure clarks is out of those and there not being made anymore. Mike
Re: Clarks Pinion shaft
Posted: Thu Jun 18, 2015 3:38 pmAnd if they are out of stock i have a good one will sell. Mike
Re: Clarks Pinion shaft
Posted: Tue Jun 23, 2015 10:48 amI want to buy it Mike.
Re: Clarks Pinion shaft
Posted: Fri May 06, 2016 8:12 pmI use the pinion shaft with no problems on many autocross races.
Dave
Dave